Description
Boosts Overall Off-Road Function and Aesthetic. The Barricade Extreme HD Front Bumper with LED Fog Lights is the ultimate off-road accessory that your non-Rebel Dodge RAM 1500 truck needs. It protects your front end from objects, flying debris, and impact from other vehicles, and it comes with a pair of cube-shaped LED lights to cut through hard-to-see situations. It also helps that it will make your truck look bad-ass: with its black finish and sharp edges
Includes LED Fog Lights for Increased Visibility. The integrated fog lights are a nice bonus, saving you hundreds of dollars adding them yourself. These super-bright and long-lasting 3-inch CREE LED lights need just 5 watts each to produce a nice white light at a color temperature of 6000k. The IP67 aluminum housing with polycarbonate lens ensure that they will not be harmed by water or dust. And included is a wire control that will run through your dashboard to conveniently switch them on and off.
Super-Tough Steel Construction. Crafted from a 5/32-inch steel plate, this front bumper will not succumb to exposure or impact. And with its black powder coat, you will never have to worry about it rusting.
Medium-Level Bolt-On Installation. No drilling is required to install this front bumper, which bolts onto the front. Shipped with it are all the components necessary to complete installation. It should take about 2 hours or more, depending on how you handle the sheer heaviness of the bumper; recruiting a co-installer is highly recommended.
Application. The Barricade Extreme HD Front Bumper with LED Fog Lights is designed to fit 2019-2023 Dodge RAM 1500 models except the Rebel. Does not fit RAM 1500 Classic models. It is sold individually.
Jessie C (verified owner) –
Bumper looks great but only issue is that the factory harness for parking sensor doesn’t reach each sensor do that would require cutting and extending the wires.
Dru C (verified owner) –
Only one thing comes to mind to describe this bumper, a HUGE step on the front of my truck. I wanted clean lines from the sides and front and i was truely disappointed how bad this bumper does not line up with the body of the truck..
Bumper sticks out 5” from the grill with a quarter to half inch gap from the body, doesnt push up under the grill. The mounting bracket bolt holes prevent it from sliding back, also the angle brackets for the mounts.
The top trim piece is a half inch short in length so if the bumper did push back it would hit the grill.
Bumper is 1” to wide leaves a ½ inch overhang on either sided of the truck.
The sensor mounts are steel with little plastic caps that do not fit tight and come loose they should have just made the holes for the sensors and you used the factory brackets….
The fog lights did not attach to the factory wiring harness
All in all this bumper destroyed the clean lines of the truck because the designer didn’t take the time to measure and adjust it to the lines of the truck. It should be push back 3-4″ inches and the width shortend a 1″ so the sides are flush. Also the top trim piece needs to be redesigned.